Maytag MDB7100AWS User Manual

Theupperrackcanberemovedwhentall
oroversizeditemsneedtobeloadedinto
thelowerrack.
TO REMOVE:
Roll the upper rack 1/3 to 1/2 of the
way out.
;_ Remove the plastic rack stop from the
end of each track. To remove each
plastic rack stop, push inward
(towards the rack) on the ridged area
of the rack stop. The rack stop will
snap open and can be easily removed
by pulling straight out. Take care to
support the track while removing rack
stops.
Roll the rack all the way out of the
track and remove from the dishwash-
er.
Reverse the above procedure to
replace the upper rack into the dish-
washer.
Rack
APORTABLE
1. Turn on the faucet at the sink until the
water runshot. Turn off the faucet.
2. Pull the connector from the recess in
the back of the dishwasher.
3. Press down on the thumb release and
liftthe connector onto the faucet.
4. Remove pressure from the thumb
release and tug slightly on the connec-
tor to be sure it is securelyin place.
5. Turn the hotwater on full force.
6. Check that the sink drain is open so
water from the dishwasher can drain
properly.
7. Pullthe electrical cord from the recess.
Plug it intoa properlygrounded outlet.
8. Select the proper cycle and options for
the load and startthe dishwasher.
1(IIII(III i
1. Be sure to turn the water supplyoff and
press the pressure release button
BEFORE removingthe connector.
2. Press down on the thumb releaseand
remove the connectorfrom the faucet.
Stop
3. Push the connector and hoses back
into the cabinet recess.
4. Unplug the electrical cord and push it
back intothe cabinet recess.
Pressure 4
Release
Button

Maytag MDB7100AWS Specifications

General

Brand	Maytag
Model	MDB7100AWS
Category	Dishwasher
Language	English