6
Installation
5. Grasp the handle firmly and slide
down.
To Remove:
1. Grasp the lower part of the handle
firmly, slide up, lift and remove from
the surface.
Handles
Remove and discard handle packaging and tape.
Plastic Handle
To Install:
1. The handles are to be oriented
as shown.
2. Align door handle clip with the
door studs.
Note: If not installed, the handle is located in the
interior of the fresh food section or attached to the
back of your refrigerator.
4. Rotate the handle so that the
handle is flat against the door.
3. Ensure the large hole in the
mounting clip is positioned
down on both ends of the
handle.
Door
Stud
To Next Page
Loading...
