9
P.01 P. WHITES AND COLORS COOL DOWN TIME
01 Represents the degree in Fahrenheit temperature (plus 100 degrees). Example 01 equals 1
minute of cool down time. By pressing the WHITES and COLORS keypad you can adjust the
value from 1 to 3 minutes.
Press PERMANENT PRESS keypad once to advance to next code.
P.03 P. PERMANENT PRESS COOL DOWN TIME
03 Represents the number of minutes of cool down. Example: 03 equals 3 minutes of cool down
time. By pressing the WHITES and COLORS keypad you can adjust the value from 1 to 3
minutes.
Press PERMANENT PRESS keypad once to advance to next code.
P.03 P. DELICATES COOL DOWN TIME
03 Represents the number of minutes of cool down. Example: 03 equals 3 minutes of cool down
time. By pressing the WHITES and COLORS keypad you can adjust the value from 1 to 3
minutes.
If cycle counter (90C) is selected, the following will display:
100 Represents the number of cycles in HUNDREDS. 1
02 = 200
200 Represents the number of cycles in ONES. 2 25 = 25
TOTAL = 225 cycles
This is VIEW ONLY and
cannot be altered.
Press PERMANENT PRESS keypad once to advance to next code.
If money counter (1.0C or 1.C0) is selected, the following will display:
300 Number of dollars in HUNDREDS 3
01 = 100
400 Number of dollars in ONES. 4 68 = 68
500 Number of CENTS 5 75 = 75
TOTAL = $168.75
END of SETUP PROCEDURES.
EXIT FROM SETUP MODE
Reinstall access door.
SECTION V
DIAGNOSTIC CODES
If the setup mode is entered and one of the following has occurred, the appropriate diagnostic code will be in
the display.
STACKED DRYERS
d2 Lower dryer thermistor circuit error on control board (cycles disabled on lower machine until diagnostic
code is manually cleared).
d3 Lower dryer temperature too high (cycles disabled on lower machine until diagnostic code is manually
cleared).
To Next Page
Loading...
