EasyManuals Logo

Maytag MVWC565FW User Manual

Maytag MVWC565FW
36 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #11 background imageLoading...
Page #11 background image
11
Operate your washer only when you are home. If moving, or
not using your washer for a period of time, follow these steps:
1. Unplug or disconnect power to washer.
2. Turn off water supply to washer, to avoid flooding due
to water-pressure surge.
WINTER STORAGE CARE
IMPORTANT: To avoid damage, install and store washer
where it will not freeze. Some water may stay in hoses, and
freezing can damage washer. If storing or moving during
freezing weather, winterize your washer.
To winterize washer:
1. Shut off both water faucets; disconnect and drain
water-inlet hoses.
2. Put 1 qt. (1 L) of R.V.-type antifreeze in basket and run
washer on Rinse & Spin cycle for about 30 seconds to mix
antifreeze and remaining water.
3. Unplug washer or disconnect power.
NON-USE AND VACATION CARE
TRANSPORTING YOUR WASHER
1. Shut off both water faucets. Disconnect and drain
water-inlet hoses.
2. If washer will be moved during freezing weather, follow
“Winter Storage Care” directions before moving.
3. Disconnect drain hose from drain system and drain any
remaining water into a pan or bucket. Disconnect drain
hose from back of washer.
4. Unplug power cord.
5. Place inlet hoses and drain hose inside washer basket.
6. Drape power cord over edge and into washer basket.
7. Place packing tray from original shipping materials back
inside washer. If you do not have packing tray, place heavy
blankets or towels into basket opening. Close lid and place
tape over lid and down front of washer. Keep lid taped
until washer is placed in new location. Transport washer in
upright position.
REINSTALLING/USING WASHER AGAIN
To reinstall washer after non-use, vacation, winter storage,
or moving:
1. Refer to Installation Instructions to locate, level, and
connect washer.
2. Before using again, run washer through the following
recommended procedure:
To use washer again:
1. Flush water pipes and hoses. Reconnect water-inlet hoses.
Turn on both water faucets.
2. Plug in washer or reconnect power.
3. Run washer through Bulky/Sheets cycle to clean washer
and remove any antifreeze. Use half the manufacturer’s
recommended amount of detergent for a medium-size load.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Maytag MVWC565FW and is the answer not in the manual?

Maytag MVWC565FW Specifications

General IconGeneral
StyleTop-Loading
ColorWhite
Washer Capacity4.2 cu ft
Dryer Capactity-
Max Spin Speed660 RPM
Spin Speeds-
Spin ClassE
Number of Cycles11
Cycle SelectionsNormal - Heavy
WashSpeed Wash
OptionsDelay Start
No spin and No heatFabric Softener
HoursCold-Wash
Noise level-
Temperature Selections6
Cold)Cold)
Control Panelknobs
Interior Lightno
Steamno
Add Washyes
Energy Class-
Annual Energy Consumption164 kWh
Annual Water Consumption-
Water Consumption Per Cycle-
Voltage120 V
Frequency-
Current15 A
Electrical Requirements120v, 60hz
Number of Options5
Temperature Settings5
Soil Levels3 (heavy, light, normal)
Wi-Fino
Weight and Dimensions IconWeight and Dimensions
Depth27 in
Height51-1/4 in
Width27-1/2 in
Net Weight141 lbs

Related product manuals