Maytag MVWC565FW User Manual

13
First try the solutions suggested here or visit our website at www.maytag.com/product_help -
In Canada www.maytag.ca for assistance and to possibly avoid a service call.
TROUBLESHOOTING
Washer won’t run or fill,
washer stops working,
or wash light remains
on (indicating that the
washer was unable to fill
appropriately) (cont.)
Check proper electrical supply. Plug power cord into a grounded 3 prong outlet.
Do not use an extension cord.
Ensure there is power to outlet.
Reset a tripped circuit breaker. Replace any blown fuses.
NOTE: If problems continue, contact an electrician.
Normal washer operation. Lid must be closed for washer to run.
Washer will pause during certain phases of cycle. Do not
interrupt cycle.
Washer may be tightly packed. Remove several items, rearrange load evenly in basket. Close lid and
press START/PAUSE.
Do not add more than 1 or 2 additional items after cycle has started
to avoid tightly packing or unbalancing.
Do not add more water to the washer.
Washer not draining/
spinning, loads are
still wet, or spin light
remains on (indicating that
the washer was
unable to pump out water
within 10 minutes)
Small items may have been caught
in pump or between basket and tub,
which can slow draining.
Empty pockets and use garment bags for small items.
Use a cycle with a low spin speed. Cycles with lower spin speeds remove less water than cycles
with high spin speeds. Use the recommended cycle/spin speed
for your garment. To remove extra water in the load, select
Drain/Spin. Load may need to be rearranged to allow even
distribution of the load in the basket.
The washer may be tightly packed
or unbalanced.
Tightly packed or unbalanced loads may not allow the washer
to spin correctly, leaving the load wetter than normal. Evenly
arrange the wet load for balanced spinning. Select the Drain/
Spin cycle to remove excess water. See “Using Your Washer”
for loading recommendations.
If you experience Possible Causes Solution
Washer Not Performing As Expected (cont.)
Washer won’t run or fill,
washer stops working,
or wash light remains
on (indicating that the
washer was unable to fill
appropriately)
Check for proper water supply. Both hoses must be attached and have water flowing to
inlet valve.
Both hot and cold water faucets must be turned on.
Check that inlet valve screens have not become clogged.
Check for any kinks in inlet hoses, which can restrict water flow.

Maytag MVWC565FW Specifications

General

Style	Top-Loading
Color	White
Washer Capacity	4.2 cu ft
Dryer Capactity	-
Max Spin Speed	660 RPM
Spin Speeds	-
Spin Class	E
Number of Cycles	11
Cycle Selections	Normal - Heavy
Wash	Speed Wash
Options	Delay Start
No spin and No heat	Fabric Softener
Hours	Cold-Wash
Noise level	-
Temperature Selections	6
Cold)	Cold)
Control Panel	knobs
Interior Light	no
Steam	no
Add Wash	yes
Energy Class	-
Annual Energy Consumption	164 kWh
Annual Water Consumption	-
Water Consumption Per Cycle	-
Voltage	120 V
Frequency	-
Current	15 A
Electrical Requirements	120v, 60hz
Number of Options	5
Temperature Settings	5
Soil Levels	3 (heavy, light, normal)
Wi-Fi	no

Weight and Dimensions

Depth	27 in
Height	51-1/4 in
Width	27-1/2 in
Net Weight	141 lbs