f_-,
Replacing mnterior
Instructions for replacing the bulb:
l)
2)
Light .....................................
Unplug or disconnect the clothes washer from the electrical power supply1
Open the door and use a Phillips screwdriver to remove the screw attaching the light
cover to the door lock assembly
3) Pull down on the light cover,
4) Unscrew the light bulb counter clockwise fi'om the socket.r
5) Replace the bulb with a !0 watt candelabra base light bulb and rotate clockwise,
6) Replace the light cover by inserting the fiont tabs into the door lock assembly and
push the rear of light cover into position,.
7) Replace the screw into the light cover/door lock assembly,,
8) Plug in or reconnect clothes washer to the power' supply
Reversing the Clothes Washer Door ..................
Clothes washer door swing direction can be successlhlty changed using the following procedure:
1) Swing door fully open and support it while removing [0ur hinge screws (which hold hinges to door assembly)
2) Set door aside and transfer four' color matched door screws to the opposite side of the door assembly.
3) Remove one screw holding top hinge to cabinet and one screw holding top hinge cover to cabinet (opposite side)..
4) Remove hinge and bracket from cabinet by moving them up and down to a position where they are released.
5) [nstall hinge and bracket in swapped locations and drive screws to attach them securely to the cabinet.
6) Compare top hinge and top bracket to bottom hinge and bottom bracket for correct assembly position.
7) Repeat procedures 4 through 6 for bottom hinge to cabinet and bottom bracket to cabinet
8) Support door in fully open position on hinge side and drive four screws to securely attach hinges to door'
assembly,
9) Close door and check to see that clothes washer operates properly,
/
,.÷ - -r ....... __..-__ _ o
Ill • •
,,_ ',\ ] 4'
I I \\_ ,t 11
/
Counter Sunk Screw_ '_
--- Door
_ Screws
Ho e
Covers
-'---- Door
" " _ Screws
9
To Next Page
Loading...
Need help?
General