Stops
Leaks Water
Is Noisy
Fills with
the Wrong
Temperature
Water
Cycle Selector
Knob Advances
Through "off"
]Sab is
Completely
Full of Suds
• Plug cord into live electrical outlet
• Check fuse or reset circuit breaker
• Turn the control dial to proper cycle and push the START/STOP button to
start the clothes washer If equipped with buttons, be sure they are fully
depressed°
• Close door and push the START/STOP button to start the clothes washer. For
your safety, washer wilt not tumble or spin unless door is closed
• This may be a pause or soak period in the cycle, Wait briefly and it may start.
• Make sure hose connections are tight,
. Make sure end of drain hose is correctly inserted and secured to drain facilit?/.
- Avoid overloading,
- Clothes washer should be leveled properly as
instructions.
• Weak floors can cause vibration and walking_
- Be sure rubber feet me installed on leveling legs,
- Check the leveling leg lock nuts are tightened
outlined in installation
- Turn both faucets on fully.,
• Check that the ternperature selector button is fully depressed
" Make sure temperature selection is correct.,
• Make sure hoses are connected to correct faucets and inlet connections, Flush
water line before filling washer.
- Check the water heater, It should be set to deliver a minimum t20°F (49°C)
hot water at the tap, Also check water heater' capacity and recovery rate.
° Disconnect hoses and clean screens. Hose filter screens may be plugged,
- Extra rinse option is selected
• Run the clothes washer through another complete cycle using cold water_
• Reduce detergent amount for' that specific load size and soil level
• Use high efficiency or low sudsing detergent specially formulated for front
load washers.
Foe fig#ther a_S[gtimc¢, r Ml_lk)_tag Llu_lo_mer,_}N._k _l_f_O a_ i-888.'.4'-.MA,_TAG. (I.888-462,9824).
U°S. customers using 'T_j_o(deaf, heqri_ iinp_ired Orspeech impaired, call 1-800-688-2080,
11
To Next Page
Loading...
Need help?
General