5
UU
SING THE WASHER CONTROLS
Step 4
NO
TE:
The wash cycle is complete when the contr
ol dial points to “OFF” and the
“Door Locked” light is no longer lit.The door should open easily.
LOAD THE CLOTHES WASHER
• The tub can be loaded completely full with dry unfolded
clothes. However, do not pack the tub tightly.
• Overloading may reduce washing efficiency and possibly
cause creasing or wrinkling of the load.
• For best cleaning results when washing a large bulky
item that does not completely fill the tub, (such as a rug)
add a few towels to complete the load.This will help to
balance the load.
•
To load a forgotten item immediately after
the clothes washer has started,
press the
START/STOP button.The door will remain unlocked
for approximately 3 minutes into the start of the cycle.
Add the item(s), close the door and press the
ST
ART/STOP
button to r
esume the cycle.
• Once the door has locked, it is possible to
load a forgotten item.
Press the START/STOP
button and wait approximately 2 minutes for the “Door
Locked” indicator to turn off. Open the door, add the
item(s), close the door and press the START/STOP
button to resume the cycle.
• Add laundry detergent on top of the load in the tub, then
place additives in the properly marked dispensers. (See
W
asher Features page 6).
Step 5
START YOUR MAYTAG NEPTUNE
TM
WASHER
1. Close the washer door.
2. Push the
START/STOP button.
3. The washer has started when the ON light is lit and an audible tone is heard.
INDICATOR LIGHTS
• DOOR L
OCKED
– Lights whene
v
er the door of the clothes washer is locked.The
door can be unlocked by pressing the
START/STOP button to stop the clothes
washer. It may take approximately 2 minutes for the door to be unlocked.
•
ON – Light indicates when the clothes washer is operating.
To Next Page
Loading...
Need help?
General