Maytag W10680141C - User Manual

Questions and Answers

A
Angela WilliamsAug 20, 2025
How to fix a Maytag Dryer that will not start?
- M
  Melissa MontesAug 20, 2025
  If your Maytag dryer isn't running, there are several possible causes. First, ensure that the dryer door is completely closed. Then, make sure you firmly touch and hold the START button for 2-5 seconds. Also, check your household fuses or circuit breakers; electric dryers often have two. Replace any blown fuses or reset tripped breakers. If it still doesn't work, the dryer might not be receiving the correct power supply (electric dryers need 240-volt or 208-volt). In this case, consult a qualified electrician. Finally, ensure you are using a time-delay fuse.
B
Barbara ShawAug 25, 2025
Why is my Maytag Dryer not heating up?
- L
  lawrenceteresaAug 25, 2025
  If your Maytag dryer isn't heating, the drum may be turning, but there could be a problem with the heat source. For electric dryers, check both household fuses or circuit breakers, as they use two. Replace any blown fuses or reset tripped breakers. If the issue persists, consult a qualified electrician to ensure the dryer is receiving the correct 240-volt or 208-volt power supply. For gas dryers, verify that the valve on the gas supply line is open.
J
Jeremy BlackAug 26, 2025
What to do if my Maytag W10680141C Dryer is making a rattling noise?
- D
  daryl06Aug 26, 2025
  If your Maytag dryer is making a rattling or vibrating noise, it could be due to several reasons. Check the front and rear edges of the drum for small objects that may be caught. Also, ensure the dryer is properly leveled, with all four feet in firm contact with the floor. Uneven leveling can cause vibrations. Finally, if clothing is balled up inside, separate the items and restart the dryer.
B
Brendan WilliamsonAug 28, 2025
How to prevent lint on clothes in my Maytag W10680141C?
- K
  Kristina YoungAug 28, 2025
  To prevent lint on your clothes when using your Maytag dryer, make sure to clean the lint screen before each load.
B
brett71Aug 29, 2025
How to get wrinkles out of clothes in my Maytag W10680141C?
- N
  nicholasholmesAug 29, 2025
  To reduce wrinkles in your clothes when using your Maytag dryer, make sure you remove the load immediately at the end of the cycle. For existing wrinkles, you can select the Steam Refresh Cycle (on some models) to tumble the load with water and heat. Also, avoid tightly packing the dryer; dry smaller loads that can tumble freely. If using steam cycles, ensure water is properly connected to the dryer, with the inlet hose connected to both the faucet and the dryer’s water inlet valve, and that the water supply is turned on.
S
susanknoxAug 31, 2025
Why is the cycle time so short on my Maytag Dryer?
- W
  William WatsonAug 31, 2025
  If the cycle time on your Maytag dryer seems too short, it could be because the load isn't contacting the sensor strips properly during Sensor Cycles. Make sure the dryer is level, with all four feet firmly on the floor. If you're using the Steam Refresh cycle for only one or two items, add a towel to help avoid uneven spraying from the steam valve. Adjust the cycle time accordingly. Also, you can change the dryness level setting on Sensor Cycles. Increasing or decreasing the dryness level will change the amount of drying time in a cycle.
R
ravenperezSep 2, 2025
What to do if my Maytag W10680141C won't turn off?
- J
  Joseph NolanSep 2, 2025
  If your Maytag dryer won't turn off, it might be because the dryer door was opened before the Wrinkle Prevent option finished. If this happens, the dryer goes into Pause mode. To turn it off, touch the Power button. Alternatively, touch Start/Pause to continue the Wrinkle Prevent cycle.
W
walshkathleenSep 4, 2025
Why are there stains on my clothes after using my Maytag W10680141C Dryer?
- P
  Phillip HobbsSep 4, 2025
  If you're noticing stains on your clothes after using your Maytag dryer, it might be due to improper use of fabric softener. Add dryer fabric softener sheets at the beginning of the cycle, as adding them to a partially dried load can cause stains. Also, avoid using fabric softener sheets with steam cycles.
M
Michael Abbott DVMSep 6, 2025
Why is my laundry load too hot after using my Maytag Dryer?
- M
  Matthew VegaSep 6, 2025
  If your laundry load is too hot after using your Maytag dryer, it could be because the load was removed before the cool-down portion of the cycle was complete. Allow the dryer to finish the entire cycle, including the cool-down. Alternatively, if you're using a Timed Dry cycle with a high-temperature setting, switch to a Sensor Cycle with a lower heat setting to prevent overdrying.
D
Danielle GomezSep 8, 2025
How to remove odors from my Maytag W10680141C and clothes?
- C
  Carrie RobertsSep 8, 2025
  If you notice odors coming from your Maytag dryer or lingering on your clothes, it could be due to recent painting, staining, or varnishing in the area. Ventilate the area until the odors or fumes are gone, then rewash and dry the clothing. To remove odors left in garments after wearing, use the Steam Refresh cycle (on some models), which is designed to reduce wrinkles and odors from dry loads.

Maytag W10680141C Specifications

General

Model Number	W10680141C
Brand	Maytag
Capacity	7.0 cu. ft.
Color	White
Wrinkle Control Option	Yes
Moisture Sensor	Yes
Power Source	Electric
Voltage	240V
Amperage	30A
Width	29 inches