To Next Page

To Previous Page

Locate Stud(s)

NOTE: If no wail studs exist within the cabinet opening, do not 1. Using a stud finder, locate the edges of the wall stud(s) within

install the microwave oven• the opening•

See illustrations in "Possible Wall Stud Configurations." 2. Mark the center of each stud, and draw a plumb line down

each stud center• See illustrations in "Possible Wall Stud

Configurations."

Possible Wall Stud Configurations

These depictions show examples of preferred installation configurations with the mounting plate.

No Wall Studs at End Holes

Figure 1

No Wall Studs at End Holes

Figure2

}

o ................................

}

D B '

i ;i

i i

NOTE: If wall stud is within 6" (15.2 cm) of the vertical

centerline (see "Mark Rear Wall" section), only recirculation or

roof venting installation can be done.

Wall Stud at One End Hole

Figure3

i i i i

i D ;

' i B

Wall Studs at Both End Holes

Figure4

A. End holes (on mounting plate)

B. Cabinet opening vertical centerline

C. Waft stud centerlines

D. Holes for lag screws

E. Support tabs

F. Mounting plate center markers

Maytag YMMV6190DS0 User Manual

Questions and Answers: