Mazak VTC-200C - User Manual

Operating Manual
for
VTC-200B, VTC-200C & VTC-300C
(Mazatrol Fusion 640M)
Publication # C557SG0012E
7/99
CAUTION
This Manual is published to assist experienced personnel on the operation, maintenance
and/or programming of Mazak machine tools.
All Mazak machine tools are engineered with a number of safety devices to protect
personnel and equipment from injury or damage. Operators should not, however, rely
solely upon these safety devices, but should operate the machine only after fully
understanding what special precautions to take by reading the following documentation
thoroughly.
Do not attempt to operate or perform maintenance / repair on the machine without a
thorough understanding of the actions about to be taken. If any question exists, contact
the nearest Mazak service center for assistance.
Certain covers, doors or safety guards may be open or removed to more clearly show
machine components. These items must be in place before operating the machine.
Failure to comply with this instruction may result in serious personal injury or damage to
the machine tool.
This manual was considered complete and accurate at the time of publication, however,
due to our desire to constantly improve the quality and specification of all Mazak
products, it is subject to change or modification.
Return to Library

Summary

Sec. 1: Introduction

2 SAFETY PRECAUTIONS

Details crucial precautions for safe operation, covering general rules, personal safety, operational safety, and specific hazards.

Sec. 2: Machine Operation

2 OPERATION PANELS

3 MANUAL OPERATION

Covers procedures for starting, operating, and stopping the machine manually, including checks and warm-up.

4 PREPARING FOR MACHINING

Sec. 3: Operating NC Unit & Preparation for Auto Operation

1 PREPARATION FOR AUTOMATIC OPERATION

3 DATA SETTING METHODS

5 DISPLAYS RELATED TO MACHINING SET UP

Sec. 4: Automatic Operation

1 AUTOMATIC OPERATION EXECUTION

Describes the procedures for executing automatic operation, including program selection and condition settings.

2 SELECTING EXECUTION CONDITIONS

3 CHANGING THE CUTTING CONDITIONS

4 STOPPING AUTOMATIC OPERATION

Provides methods for safely stopping automatic operation, including emergency stop, reset, feed hold, and power off.

Sec. 5: Appendix

2 ALARM LIST

Provides a comprehensive list of machine alarms: numbers, names, descriptions, machine status, and sensor detection.

3 M CODE LIST

Mazak VTC-200C Specifications

General

Brand	Mazak
Model	VTC-200C
Category	Industrial Equipment
Language	English