3-6
Knowing Your Mazda
Doors and Locks
Form No. 8R21-EA-02G
▼
Transmitter Maintenance
Replacing the transmitter battery
1. Insert a small screwdriver into the slot
and gently pry open the transmitter.
2. Remove the battery.
•
Make sure the battery is installed
with the correct pole facing upward.
Battery leakage could occur if it is
not installed correctly.
•
When replacing the battery, be
careful not to bend the electrical
terminals or get oil on them. Also
be careful not to get dirt in the
transmitter as it could damage it.
•
Danger of explosion if battery is
incorrectly replaced.
•
Replace only with the same type
battery (CR2025 or the equivalent).
•
Dispose of used batteries according
to the following instructions.
• Insulate the plus and minus
terminals of the battery using
cellophane or equivalent tape.
• Never disassemble.
• Never throw the battery into fire
and/or water.
• Never deform or crush.
CAUTION
Back cover
Slot
J16L_8R21-EA-02G.book Page 6 Saturday, June 8, 2002 11:16 AM
To Next Page
Loading...
Need help?
General
