Black plate (195,1)
l
A new CD may have rough edges on
its inner and outer perim eters. If a disc
with rough edges is used, proper
setting will not be possible and the In-
dash CD changer will not play the CD.
In addition, the disc may not eject
resulting in a malfunction. Remove the
rough edges in advance by using a ball-
point pen or pencil as shown below. To
remove the rough edges, rub the side of
the pen or pencil against the inner and
outer perimeter of the CD.
l
When driving over uneven surfaces,
the sound may jump.
l
The In-dash CD changer has been
designed to play CDs bearing the
identification logo as shown. No other
discs can be played.
l
Use discs that have been legitimately
produced. If illegally-copied discs such
as pirated discs are used, the system
may not operate properly.
l
Be sure never to touch the signal
surface when handling the CDs. Pick
up a CD by grasping the outer edge or
the edge of the hole and the outer edge.
l
Do not stick paper or tape on the CD.
Avoid scratching the reverse side (the
side without a label). The disc may not
eject resulting in a malfunction.
l
Dust, finger smudges, and dirt can
decrease the amount of light reflected
from the signal surface, thus affecting
sound quality. If the CD shoul d
become soiled, gently wipe it with a
soft cloth from the center of the CD to
the edge.
Interior Comfort
Audio System
6-15
Mazdaspeed6_8V77-EA-06F_Edition1 Page195
Tuesday, May 9 2006 10:45 AM
Form No.8V77-EA-06F
To Next Page
Loading...
