Black plate (206,1)
Blind Spot Monitoring (BSM) System
í
The Blind Spot Monitoring (BSM) syste m is designed to assist the driver by monitoring
blind spots on both sides of the vehicle to the rear in certain situations such as when
changing lanes on roads and freeways.
The BSM system monitors the detection areas on both sides of the vehicle to the rear when
the vehicle speed is about 32 km/h (20 mph) or more, and notifies the driver of vehicl es in
the detection area by illuminating the BSM warning light.
If the turn signal lever is operat ed in the direction the BSM warning light is illuminate d, the
system warns the driver of the vehicle in the detection area with a beep sound.
Detection areas
WARNING
Do not rely completely on the BSM system and be sure to look over your shoulder
before changing lanes:
The BSM system can assist the driver in confirming the safety of the surroundings
but is not a complete substitute. The driver is responsible for assuring lane changes
and other maneuvers. Always pay attention to the direction in which the vehicle is
traveling and th e vehicle's surroundings.
NOTE
l
The BSM system does not operate when the vehicle speed is lower than about 32 km/h (20 mph).
l
The radar sensors are equipped inside the rear bumper. (page 5-37)
l
The system may not operate normally when towing a trailer. Turn off the system by operating the
BSM OFF switch when towing a trailer.
l
The radar sensors do not detect human, animal, or static objects such as fences. In addition, the
system pauses when the selector lever is shifted to the R position. (The system resumes
automatically when the selector lever is shifted from the R position.)
5-34
Driving Your Mazda
í
Some models.
Starting and Driving
CX-9_8BH3-EC-10H_Edition1 Page206
Friday, July 30 2010 2:59 PM
Form No.8BH3-EC-10H
To Next Page
Loading...
