Black plate (20,1)
NOTE
l
If the seat is already adjusted to the
position you are activating, the seat does
not move (a beep sound is not heard).
l
The advanced key/retractable key cannot be
programmed while the key is inserted in the
key cylinder.
l
If any of the following operations is
performed while activating a seat, the
activation will cancel (After pressing a
programming button or unlocking the doors
with a programmed advanced key/
retractable type key, and while the positions
are being adjusted).
l
The selector lever is shifted to a position
other than P (The ignition is switched
ON).
l
Any of the seat adjustment switches
other than a lumbar support switch are
operated.
l
The SET button is pressed.
l
A programming button (1, 2, or 3) is
pressed.
l
Vehicle locking/unlocking is done using
the transmitter.
l
The vehicle starts moving.
l
(To cancel the seat activation when using
a programmed advanced key/retractable
type key to unlock the doors)
Perform the following procedure.
l
Switch the ignition off.
l
Press the SET button next to the
programming button (1, 2, or 3) and
then the lock button on the advanced
key/retractable type key within about 5
seconds. A beep sound is heard after the
operation is completed.
qLumbar Support Adjustment
(Driver's Seat)
Manually operated
To increase the seat firmness, pull the
lever forward. Push the lever backward to
decrease firmness.
Electrically operated
The amount of lumbar support can be
adjusted by pressing the switch.
To increase the seat firmness, press and
hold the front part of the switch to the
desired position, then release it.
Press the rear part of the switch to
decrease firmness.
2-8
Essential Safety Equipment
Seats
CX-9_8BH3-EC-10H_Edition1 Page20
Friday, July 30 2010 2:57 PM
Form No.8BH3-EC-10H
To Next Page
Loading...
