Black plate (463,1)
NOTE
l
Make sure the jack is well lubricated before
using it.
(With Tire Pressure Monitoring System)
l
Be sure to register the tire pressure sensor
ID signal code whenever tires or wheels are
changed (page 5-32).
1. Park on a level surface off the right-of-
way and firmly set the parking brake.
2. Shift into Park (P) and turn off the
engine.
3. Turn on the hazard warning flasher.
4. Have everyone get out of the vehicle
and away from the vehicle and traffic.
5. Remove the jack, tool, and spare tire
(page 7-3).
6. Block the wheel diagonally opposite
the flat tire. When blocki ng a wheel,
place a tire block both in front and
behind the tire.
NOTE
When blocking a tire, use rocks or wood blocks
of sufficient size if possible to hold the tire in
place.
qRemoving a Flat Tire
1. Loosen the lug nuts by turning them
counterclockwise one turn each, but do
not remove any lug nuts until the tire
has been raised off the ground.
2. Place the jack under the jacking
position closest to the tire being
changed.
Jacking position Jacking position
In Case of an Emergency
Flat Tire
7-9
CX-9_8BH3-EC-10H_Edition1 Page463
Friday, July 30 2010 3:1 PM
Form No.8BH3-EC-10H
To Next Page
Loading...
