Trunk light
1. Press both sides of the lens cap to
remove it.
2. Disconnect the bulb by pulling it out.
3. Install the new bulb in the reverse order
of removal.
Fuses
Your vehicle's electrical system is
protected by fuses.
If any lights, accessories, or controls don't
work, inspect the appropriate circuit
protector. If a fuse has blown, the inside
element will be melted.
If the same fuse blows again, avoid using
that system and consult an Authorized
Mazda Dealer as soon as possible.
qFuse Replacement
Replacing the fuses on the driver's side
kick-panel
If the electrical system does not work,
first inspect the fuses on the driver's side
kick-panel.
1. Make sure the ignition is switched off,
and other switches are off.
2. Open the fuse panel cover by sliding
the cover straight back toward you.
CAUTION
Pulling the cover off sideways may
break the retaining tabs off.
Maintenance and Care
Owner Maintenance
8-47
Mazda6_8CD2-EC-11D_Edition1 Page445
Friday, April 15 2011 1:7 PM
Form No.8CD2-EC-11D
To Next Page
