Mazda 2016 CX3 - Page 572

9 – 16
Specifi cations
Personalization Features
Item Feature
Factory
Setting
Available
Settings
Settings change method
Active
driving
display
Refer to
Active
Driving
Display
on page
4-22 .
Turn-by-Turn
(TBT)
Setting can be changed
so that the Turn-by-Turn
(TBT) of the Active
driving display is not
displayed.
On On/Off
Refer to
Active
driving
display
on page
4-22 .
—
*1 Though these systems can be turned Off, doing so will defeat the purpose of the system and Mazda recommends
that these systems remain On.
*2 For vehicles with an audio system other than the on-screen function type, the warning sound cannot be changed.
The warning sound is only a beep.
*3 Only the volume of the warning beep during Blind Spot Monitoring (BSM) operation can be changed. The
volume of the warning beep during Rear Cross Traffi c Alert (RCTA) operation cannot be changed.
*4 If the auto-wiper control is set to Off, the wiper lever
position is set to intermittent operation.
*5 If the setting is changed to Off, the following operation is performed according to the headlight switch position:
y
At position: Headlights turn off immediately after the ignition is switched off.
y
At any position other than : Headlights do not turn off after the ignition is switched off.
*6 When set to Off, the lights-on reminder is operable.
*7 The setting of the lights-on reminder can be changed with the time setting of auto headlight off function set to
Off. Refer to Lights-On Reminder on page 7-39 .
*8 Available only in display from the center display.
CX-38EH2-EA-15BEdition1.indb16CX-38EH2-EA-15BEdition1.indb16 2014/12/0910:52:482014/12/0910:52:48
Information Provided by: