Black plate (283,1)
Replacing a front fog light bulb
í
1. Remove the three screws under the
mudguard by turning them
counterclockwise, and partially open
the mudguard.
2. Turn the socket and bulb assembly
counterclockwise, and carefully pull it
rearward.
3. Disconnect the socket and bulb
assembly from the electrical connector
by pressing the tab on the connector
with your finger and pulling it.
4. Install the new socket and bulb
assembly in the reverse order of
removal.
Front turn signal light s/Side-marker
lights
1. Turn the cen ter section of the plastic
retainers counterclockwise and remove
them, then partially peel back the
mudguard.
Removal
Installation
2. Turn the socket and bulb assembly
counterclockwise and remove it.
3. Remove the bulb by pushing it in
slightly and turning it
counterclockwise.
4. Install the new bulb in the reverse order
of removal.
Maintenance and Care
Owner Maintenance
8-37
í
Some models.
Mazda5_8U38-EA-05D_Edition1 Page283
Monday, March 28 2005 2:31 PM
Form No.8U38-EA-05D
To Next Page
Loading...
