Mazda 6 2006 - A Word to Mazda Owners; Important Notes About This Manual

3
1030832 Rev.A 10/05
DIPOLE ANTENNA MOUNTING, continued
3. Route the antenna wire down the A-pillar securing it to the exist-
ing wiring using (3) of the supplied tie wraps. Do not secure it
directly to the sunroof drain tube or airbag. (FIGURE I)
4. Route the antenna wire behind the left side of the dashboard.
The antenna will be connected to the remote start control mod-
ule later.
5. Carefully reinstall A-pillar panel. There are 2 tangs on the
bottom of the panel that need to be inserted into the slots at
the bottom of the A-pillar.
Note: Be very careful not to break the white clip off or
damage the headliner while reinstalling the A-pillar
panel. Once reinstalled correctly the panel will fit tight
to the headliner. If there are gaps at the top between
the panel and headliner then the white clip is not
seated correctly.
2
HOOD SAFETY SWITCH MOUNTING
3
1. Remove the vehicle’s battery
a. Loosen the nuts on the positive and battery terminal.
(FIGURE J)
b. Disconnect and isolate the positive battery cable.
c. Remove the 10mm bolt securing the right side of the bat-
tery bracket to the shock tower. (FIGURE J)
d. Loosen the nut securing the left side battery bracket.
(FIGURE J)
e. Remove the battery bracket.
f. Carefully remove the vehicle’s battery and set aside in a
safe place to prevent damage.
2. Using the supplied (2) 1/4” self drilling screws and (2) lock washers, secure the hood safety switch
to the vehicle’s hood 2’3.5” (710mm) from the edge of the hood, measuring from the driver’s side.
(FIGURE K & L)
FIGURE J
FIGURE K
FIGURE L
FIGURE I