2-4
Essential Safety Equipment
Seats
Form No. 8Q50-EA-01G
To change the seatback angle, lean
forward slightly while raising the lever.
Then lean back to the desired position and
release the lever.
Make sure the lever returns to its original
position and the seatback is locked in
place by attempting to push it forward and
backward.
▼
▼▼
▼ Seat Tilt (Driver’s Seat)
(Manually operated model)
The seat-bottom angle can be adjusted by
rotating the dial.
(Electrically operated model)
Front height adjustment
To adjust the front height of the seat-
bottom, raise or lower the front of the
slide lifter switch on the left side of the
seat.
When returning a rear-reclined
seatback to its upright position, make
sure you support the seatback while
operating the seatback lever. If the
seatback is not supported, it will flip
forward suddenly and could cause
injury.
Lever
CAUTION
Up
Down
Dial
J94S.book Page 4 Saturday, June 23, 2001 1:04 PM
To Next Page
Loading...
