Mazda C860 V7 281A - User Manual

1
GENUINE PARKING SENSORS (Rear)
INSTALLATION INSTRUCTIONS
Thank you for purchasing a genuine Mazda accessory.
Before removal and installation, be sure to thoroughly read these instructions.
Please read the contents of this booklet in order to properly install and use the parking sensors
(Rear). Your safety depends on it.
Keep these instructions with your vehicle records for future reference.
 There are several WARNING and CAUTION sections in this booklet concerning safety when
installing or removing the parking sensors (Rear). Always read and follow them in order to prevent
injuries, accidents, and possible damage to the vehicle.
WARNING: Indicates a situation in which serious injury or death could result if the warning
is ignored.
CAUTION: Indicates a situation in which bodily injury or damage to the vehicle could result if the
caution is ignored.
 For areas indicating the tightening torque in this instruction manual, tighten to the specified torque using
a torque wrench.
 Do not modify the parking sensors (Rear).
 Do not install the parking sensors (Rear) remove in any way other than described in the following
instructions.
 If in any doubt, please ask your Mazda dealer to install the accessory in order to prevent errors in
installation.
 If you have any questions about the use of the accessory, ask your Mazda dealer for proper advice
before using it.
 Mazda and its suppliers are not responsible for injuries, accidents, and damage to persons and property
that arise from the failure of the dealer or installer to follow these instructions.
 To ensure safety and reliability of the work, installation, removal and disposal work must be carried out
by an Authorized Mazda Dealership.
 Be careful not to lose removed parts, and be sure that they are kept free from scratches, grease or
other dirt.
PART NAME: Parking Sensors (Rear)
VEHICLE: MAZDA CX-5
PART NUMBER: KB7W V7 290A (Parking Sensors, Main Kit)
C860 V7 281A (Parking Sensors, Sensor Kit)
KD33 V7 282
(Optional ON-OFF switch)
To the dealer
 Please turn over these instructions to the customer after installation.
To the customer
 Keep these instructions after installation. The instructions may be necessary
for installing other optional parts or removal of this accessory.
 Should the vehicle or this accessory be resold, always leave these instructions
with vehicle for the next owner.
NOTE
06DE4313B
WARNING

Summary

INSTALLATION VIEW

PARTS LIST

BEFORE INSTALLATION

REQUIRED TOOLS

Lists all necessary tools for installation.

CONNECTION DIAGRAM

VEHICLE PART REMOVAL

Negative Battery Cable Disconnection

Crucial safety step to disconnect the negative battery cable before work.

Trunk Side Trim Removal

Procedure for removing the trunk side trim for harness routing.

Rear Bumper Removal

Detailed steps for safely removing the vehicle's rear bumper.

PAINT SENSOR

PREPARATION FOR INSTALLATION

Sensor Installation Preparation

Steps for preparing the rear bumper surface and drilling sensor holes.

HARNESS INSTALLATION

Main Harness Installation

Steps for routing and connecting the main wiring harness.

Sensor Harness Installation

Procedures for routing and connecting the sensor wiring harnesses.

OPTIONAL ON-OFF SWITCH INSTALLATION

Optional ON-OFF Switch Installation

Steps for installing the optional switch to control the parking sensor system.

RE-INSTALLATION CAUTIONS

OPERATION CONDITION

Alarm (Beeper) Sound Operation

Details the beeper sounds based on distance to obstructions.

TROUBLESHOOTING GUIDE

Mazda C860 V7 281A Specifications

General

Brand	Mazda
Model	C860 V7 281A
Category	Automobile Electronics
Language	English