Mazda KB7W V7 290A - User Manual

1
GENUINE PARKING SENSORS (Rear)
INSTALLATION INSTRUCTIONS
Thank you for purchasing a genuine Mazda accessory.
Before removal and installation, be sure to thoroughly read these instructions.
Please read the contents of this booklet in order to properly install and use the parking sensors
(Rear). Your safety depends on it.
Keep these instructions with your vehicle records for future reference.
 There are several WARNING and CAUTION sections in this booklet concerning safety when
installing or removing the parking sensors (Rear). Always read and follow them in order to prevent
injuries, accidents, and possible damage to the vehicle.
WARNING: Indicates a situation in which serious injury or death could result if the warning
is ignored.
CAUTION: Indicates a situation in which bodily injury or damage to the vehicle could result if the
caution is ignored.
 For areas indicating the tightening torque in this instruction manual, tighten to the specified torque using
a torque wrench.
 Do not modify the parking sensors (Rear).
 Do not install the parking sensors (Rear) remove in any way other than described in the following
instructions.
 If in any doubt, please ask your Mazda dealer to install the accessory in order to prevent errors in
installation.
 If you have any questions about the use of the accessory, ask your Mazda dealer for proper advice
before using it.
 Mazda and its suppliers are not responsible for injuries, accidents, and damage to persons and property
that arise from the failure of the dealer or installer to follow these instructions.
 To ensure safety and reliability of the work, installation, removal and disposal work must be carried out
by an Authorized Mazda Dealership.
 Be careful not to lose removed parts, and be sure that they are kept free from scratches, grease or
other dirt.
PART NAME: Parking Sensors (Rear)
VEHICLE: MAZDA CX-5
PART NUMBER: KB7W V7 290A (Parking Sensors, Main Kit)
C860 V7 281A (Parking Sensors, Sensor Kit)
KD33 V7 282
(Optional ON-OFF switch)
To the dealer
 Please turn over these instructions to the customer after installation.
To the customer
 Keep these instructions after installation. The instructions may be necessary
for installing other optional parts or removal of this accessory.
 Should the vehicle or this accessory be resold, always leave these instructions
with vehicle for the next owner.
NOTE
06DE4313B
WARNING

Summary

INSTALLATION INSTRUCTIONS

BEFORE INSTALLATION

VEHICLE PART REMOVAL

Negative battery cable disconnection

Procedure to safely disconnect the vehicle's negative battery cable before starting work.

Rear bumper removal

Instructions for safely removing the rear bumper assembly from the vehicle.

PAINT SENSOR

PREPARATION FOR INSTALLATION

Sensor installation

Initial steps for installing the parking sensors onto the rear bumper.

Control unit and buzzer installation

INSTALLATION OF THE HARNESS

Main harness installation

Details the routing and connection of the main wiring harness.

Sensor harness installation (Vehicle with BSM)

Sensor harness installation (Vehicle without BSM)

Sensor harness connection

Details connecting the sensor harness to the control unit.

Securing harnesses and ground wire

INSTALLATION OF OPTIONAL ON-OFF SWITCH FOR USE WHEN TOWING

Optional ON-OFF switch installation

Steps for installing the optional ON-OFF switch, including drilling and mounting.

Harness installation for ON-OFF switch

TROUBLESHOOT

Malfunction symptoms and actions

Lists common malfunctions, their inspection methods, and corrective actions.

Mazda KB7W V7 290A Specifications

General

Brand	Mazda
Model	KB7W V7 290A
Category	Automobile Electronics
Language	English