Mazda CX-5 2013 - Page 45

DTC C0061:54/C0062:54/C0063:54 [DYNAMIC STABILITY CONTROL (DSC)]
http://am.mazdaserviceinfo.com/emazda/dealersystem/service/esi/en_us/SM/2013/CX5/mv/books/mvw04/html/id0402b2901200.html[1/7/13 9:29:35 AM]
< Previous Next >
2013 - CX-5 - Brakes
DTC C0061:54/C0062:54/C0063:54 [DYNAMIC STABILITY CONTROL (DSC)]
DTC
C0061:54, C0062:54,
C0063:54
DSC HU/CM system (unperformed initialization procedure)
DETECTION
CONDITION
C0061:54
DSC HU/CM detects that the initialization procedure has
not been performed. (Lateral acceleration sensor)
C0062:54
DSC HU/CM detects that the initialization procedure has
not been performed. (Longitudinal acceleration sensor)
C0063:54
DSC HU/CM detects that the initialization procedure has
not been performed. (Yaw rate sensor)
FAIL-SAFE
FUNCTION
Illuminates the ABS warning light
*1
and TCS/DSC indicator light.
Tire pressure monitoring system warning light illuminates after flashes.
(Not illuminated/flashed depending on malfunction content.)
Inhibits the ABS
*2
, TCS
*2
, DSC
*2
, roll over mitigation (ROM)
*2
, brake
assist control
*2
, hill launch assist (HLA)
*2
, and TPMS
*2
controls.
*1
: Not illuminated depending on malfunction content.
*2
: Enabled depending on malfunction content.
POSSIBLE
CAUSE
Initialization procedure for the lateral acceleration sensor, longitudinal
acceleration sensor or yaw rate sensor not performed
SAS control module malfunction
DSC HU/CM malfunction
SYSTEM
WIRING
DIAGRAM
—
Diagnostic procedure