Mazda CX-5 2013 - Page 48

DTC C0062:76 [DYNAMIC STABILITY CONTROL (DSC)]
http://am.mazdaserviceinfo.com/emazda/dealersystem/service/esi/en_us/SM/2013/CX5/mv/books/mvw04/html/id0402b2901000.html[1/7/13 9:29:40 AM]
Switch the ignition to off.
Using the M-MDS, perform the DTC
inspection for the SAS control module.
(See
DTC INSPECTION [STANDARD
DEPLOYMENT CONTROL SYSTEM]
.)
(See
DTC INSPECTION [TWO-STEP
DEPLOYMENT CONTROL SYSTEM]
.)
Are any DTCs detected?
(See
DTC TABLE [STANDARD
DEPLOYMENT CONTROL SYSTEM]
.)
(See
DTC TABLE [TWO-STEP
DEPLOYMENT CONTROL SYSTEM]
.)
No Go to the next step.
3
PERFORM DSC RELATED PARTS SENSOR
INITIALIZATION
Perform the DSC related parts sensor
initialization for the PCM using the M-MDS.
(See
DSC RELATED PARTS SENSOR
INITIALIZATION PROCEDURE
.)
Is the DSC sensor initialization completed
normally?
Yes Go to the next step.
No Replace the DSC HU/CM, then go to
the next step.
(See
DSC HU/CM
REMOVAL/INSTALLATION
.)
4
VERIFY THAT THE SAME DTC IS NOT PRESENT
Clear the DTCs from the memory.
(See
ON-BOARD DIAGNOSIS [DYNAMIC
STABILITY CONTROL (DSC)]
.)
Are the same DTCs present?
Yes Repeat the inspection from Step 1.
If the malfunction recurs, replace the
DSC HU/CM, then go to the next
step.
(See DSC HU/CM
REMOVAL/INSTALLATION
.)
No Go to the next step.
5
VERIFY THAT NO OTHER DTCS ARE PRESENT
Are any other DTCs output?
Yes Go to the applicable DTC inspection.
(See
ON-BOARD DIAGNOSIS [DYNAMIC
STABILITY CONTROL (DSC)]
.)
No DTC troubleshooting completed.
< Previous Next >
Back to Top
© 2012 Mazda North American Operations, U.S.A.