DTC U0452:86 [DYNAMIC STABILITY CONTROL (DSC)]
http://am.mazdaserviceinfo.com/emazda/dealersystem/service/esi/en_us/SM/2013/CX5/mv/books/mvw04/html/id0402b2893000.html[1/7/13 9:30:44 AM]
STEP DEPLOYMENT CONTROL
SYSTEM]
.)
Are any DTCs detected?
2
VERIFY THAT THE SAME DTC IS NOT
PRESENT
Clear the DTCs from the
memory.
(See
ON-BOARD DIAGNOSIS
[DYNAMIC STABILITY CONTROL
(DSC)]
.)
Are the same DTCs present?
Yes Repeat the inspection from Step 1.
If the malfunction recurs, replace the SAS control
module, then go to the next step.
(See
SAS CONTROL MODULE
REMOVAL/INSTALLATION [STANDARD DEPLOYMENT
CONTROL SYSTEM]
.)
(See
SAS CONTROL MODULE
REMOVAL/INSTALLATION [TWO-STEP DEPLOYMENT
CONTROL SYSTEM]
.)
No Go to the next step.
3
VERIFY THAT NO OTHER DTCS ARE
PRESENT
Are any other DTCs output?
Yes Go to the applicable DTC inspection.
(See
ON-BOARD DIAGNOSIS [DYNAMIC STABILITY
CONTROL (DSC)]
.)
No DTC troubleshooting completed.
< Previous Next >
Back to Top
© 2012 Mazda North American Operations, U.S.A.
To Next Page
