Key of letters to be inserted in the above table:
U = Suitable for “universal” category restraints approved for use in this mass group.
L = For the child restraint systems categorized in this weight group, consult an Authorized Mazda Dealer.
Regarding child restraint systems which can be installed, refer to the accessories catalog.
X = Seat position not suitable for children in this mass group.
*
1 A Mazda genuine child restraint system can be installed in the forward-facing position.
*
2 When a child-restraint system is installed to the rear center seat, do not seat occupants in the rear left outboard
seat position.
NOTE
When installing a child-restraint system, the following points must be observed:
•
(Second-row seat)
Always remove the head restraint before installing a child-restraint system. However,
when installing a backless booster seat, always install the vehicle head restraint to the
seat where the backless booster seat is installed. In addition, always use a tether strap
and attach it securely. Refer to Head Restraints on page 2-18.
•
When installing a child-restraint system to the second-row seat, adjust the front seat
position so that the front seat does not contact the child-restraint system. Refer to Seat
Operation on page 2-5.
•
When installing a child-restraint system to the third-row seat, adjust the second-row seat
position so that the second-row seat does not contact the child-restraint system. Refer to
Seat Operation on page 2-5.
(Except Mexico)
Please comply with the legal regulations concerning the use of child-restraint systems in
your country.
Essential Safety Equipment
Child Restraint
2-41
CX-9_8GC3-EA-17G_Edition1 2017-5-29 10:13:38
To Next Page
Loading...
