4
–
111
When Driving
i-ACTIVSENSE
NOTE
The LDWS remains on stand-by
until it detects white or yellow lines
on both the left and right sides, or on
either side.
When the system detects a white
or yellow line on one side only, the
system will operate the warning only
when the vehicle deviates to the side
the white or yellow line detected.
Auto cancel
Under the following conditions, the
LDWS is automatically cancelled and
kept on stand-by, and the LDWS warning
light (amber) in the instrument cluster
illuminates.
The system cannot detect white or
yellow lines.
The vehicle speed is less than about 65
km/h (40 mph).
The vehicle is making a sharp turn.
The vehicle is making a turn at an
inadequate speed.
The temperature inside the camera is
high or low.
The windscreen around the camera is
foggy.
The windscreen around the camera is
blocked by an obstruction, causing poor
forward visibility.
The lane indication (bordered line) is
indicated in the active driving display
(Type A instrument cluster
*1
) or the multi
information display (Type B instrument
cluster
*1
).
The LDWS is automatically enabled when
the condition changes and the system is
operable.
*1 To determine which instrument cluster
is equipped on your Mazda, Refer to
Meters and Gauges on page 4-24 .
Auto cancel of warning
Under the following conditions, the
LDWS determines that the driver is
making lane changes and the warning is
automatically cancelled.
The LDWS is automatically enabled after
the operation.
The steering wheel is operated abruptly.
The brake pedal is depressed abruptly.
The accelerator pedal is depressed
abruptly.
A direction indicator lever is operated
(after the direction indicator lever is
returned, the LDWS warning may not
operate for about 3 seconds which is the
period of time required to make a lane
correction).
To Next Page