Mazda Mazda3 2019 - Page 93


You touch the sensing area of the
touch sensor while wearing gloves.

Foreign matter such as snow or dirt is
stuck on the sensing area of the touch
sensor.

You pull the door handle just after
touching the sensing area of the touch
sensor.

The system may operate if the outer side
door handle of a front door is splashed
with water by a car wash or rain while
the transmitter is in the operation range.

If the system does not operate even
though you touch the sensing area of the
touch sensor correctly, release the touch
sensor once, and then touch the sensing
area of the touch sensor again after
waiting about 3 seconds.
Locking
When locking, touch the sensing area of
the door lock touch sensor with all of the
following conditions met.

The ignition is switched OFF.

All the doors are closed.

You are carrying the transmitter.
The following locations are locked by
touching the sensing area of the door lock
touch sensor.

All doors

Fuel-filler flap

Liftgate/boot lid
When locking, the hazard warning lights
and sound operate one time.
Unlocking
When unlocking, touch the sensing area of
the door release touch sensor with all of
the following conditions met.

The ignition is switched OFF.

The driver’s door is locked.

Three seconds or longer have passed
since the doors were locked.

You are carrying the transmitter.
The following locations are unlocked by
touching the sensing area of the door
release touch sensor.

All doors

Fuel-filler flap

Liftgate/boot lid
NOTE

The location to be unlocked can be
changed.
Refer to the Settings section in the MZD
Connect Owner's Manual.
When unlocking, the hazard warning
lights and sound operate two times.
NOTE

Confirm that all the doors and liftgate/
boot lid are securely locked.
For the liftgate/boot lid, move it without
pressing the electric liftgate/boot lid
opener to verify that the liftgate/boot lid
has not been left ajar.

A beep sound is heard for confirmation
when the doors, fuel-filler flap, and
liftgate/boot lid are locked/unlocked
using the touch sensor. If you prefer, the
beep sound can be turned off.
The volume of the beep sound can also
be changed. Refer to the Settings section
in the MZD Connect Owner's Manual.

The setting can be changed so that the
doors, fuel-filler flap, and liftgate/boot
lid are locked automatically without
touching the sensing area of the touch
sensor.
Before Driving
Doors and Locks
3-13
Mazda3_8HC2-EO-19A_Edition1 2018-11-22 10:58:46