Temporary cancellation
If any of the following conditions is met, the MRCC with Stop & Go function is
cancelled temporarily.
x
The MRCC with Stop & Go function operation conditions are not met.
x
The CANCEL switch is pressed.
x
The brake pedal is depressed.
x
The front radar sensors cannot detect target objects.
x
The DSC has operated.
x
The Smart Brake Support (SBS) has operated.
x
The frequency of the braking operation by the MRCC with Stop & Go function is
high.
x
There is a problem in the system.
Resuming the control
If the MRCC with Stop & Go function is temporarily cancelled, it will resume
operation at the previously set speed by pressing the RES switch after all of the
operation conditions have been met again.
Turning o the system
When the MRCC switch is pressed while the MRCC is operating, the MRCC turns
o.
▼
Stop Hold Control
While in headway control using the
MRCC with Stop & Go function, your
vehicle will stop when a vehicle ahead
stops. When your vehicle is stopped
and the stop hold control operates, the
MRCC with Stop & Go function
indicator light turns on.
NOTE
x
The parking brake is automatically
applied and the vehicle is held in its
stopped position when 10 minutes
or longer have passed since the stop
hold control operated. When this
occurs, the MRCC with Stop & Go
function is temporarily cancelled.
Resuming driving
While in stop hold control, if the
vehicle ahead starts moving and the
distance from the vehicle increases, the
stop hold control will be cancelled and
your vehicle will resume driving by
performing any of the following
operations.
x
Press the RES switch.
x
Depress the accelerator pedal.
NOTE
If the vehicle ahead starts moving
within three seconds after your vehicle
is stopped, the headway control will
continue even if you do not resume
driving your vehicle.
When Driving
i-ACTIVSENSE
4-122
To Next Page
Loading...
