x
The system detects white (yellow)
lane lines on both sides.
x
There is a vehicle on the rear sides.
NOTE
x
The Blind Spot Assist function may
not operate normally when any of
the following conditions is met.
x
A condition under which the
Forward Sensing Camera (FSC)
cannot detect a target object is
met.
Refer to Forward Sensing Camera
(FSC) on page 4-74.
x
The visibility of vehicles in adjacent
lanes is poor.
x
A vehicle in an adjacent lane
rapidly approaches at a high
speed.
x
Vehicles in adjacent lanes have any
of the following shapes.
x
The vehicle size is very small.
x
The vehicle height is extremely
low or high.
x
A special type of vehicle with a
complex shape.
x
The visibility of white lines (yellow
lines) is poor (due to paint flaking
or dirt, or being hidden by vehicles
ahead).
x
There are multiple white lines
(yellow lines) or they are
interrupted.
x
A misleading line on the road is
picked up (such as temporary line
for construction, shadow, lingering
snow, or grooves filled with water).
x
The width of the vehicle lane is
narrow or wide.
x
The vehicle is shaken after hitting a
road bump.
x
The vehicle is driven on a section
with a closed lane or temporary
lane due to construction.
x
The vehicle is driven on a forked
road or junction.
x
When the ELK OFF indicator light is
on, the system is cancelled according
to a Mazda Connect setting.
Refer to the Settings section in the
Mazda Connect Owner's Manual.
Temporary cancellation of the
function
The Blind Spot Assist function goes on
stand-by when any of the following
conditions is met. The Blind Spot Assist
function is automatically restored
when its operation conditions are met.
x
The vehicle speed is less than about
55 km/h (34 mph).
x
The system cannot detect white
(yellow) lane lines.
x
The accelerator pedal is depressed
abruptly.
x
The brake pedal is depressed.
x
The steering wheel is operated
abruptly.
x
The TCS/DSC is operating.
x
The TCS/DSC is turned o.
x
Multiple vehicles are travelling in the
detecting area near your vehicle.
Cancellation of the function
The Blind Spot Assist function is
cancelled when any of the following
conditions is met.
x
The temperature in the Forward
Sensing Camera (FSC) is high or low.
x
The windscreen around the Forward
Sensing Camera (FSC) is foggy.
x
The windscreen around the Forward
Sensing Camera (FSC) is blocked by
an obstruction, causing poor forward
visibility.
When Driving
i-ACTIVSENSE
4-137
To Next Page
Loading...
