Mazda MX-30 2020 - Page 319

Rearward detection function
The rearward detection function is
designed to reduce damage in the
event of a collision with a target object
when reversing.
The rearward detection function
detects obstructions using the rear
ultrasonic sensors. In addition, if there
is the possibility of your vehicle
colliding with a target object at the rear
while you are driving in reverse, you
are
notified
of possible danger by a
warning sound and a warning
indication on the display.
Furthermore, if the possibility of a
collision increases, brake control is
performed to reduce damage in the
event of a collision.
WARNING
Always check the surrounding area
visually when reversing the vehicle:
The operation of the rearward
detection function has certain
limitations. Therefore, the function
might not operate or it might be
delayed even if there is a target object
at the rear of your vehicle. Always
make it your responsibility as a driver
to check the rear.
Operation conditions
The rearward detection function
operates when all of the following
conditions are met.
x
The EV system is operating.
x
The SBS is on.
x
The selector lever is in the R position.
x
The vehicle speed is about 2 km/h
(2 mph) to 8 km/h (4 mph).
x
There is no problem with the DSC.
x
The Electric Parking Brake (EPB) is
not operating.
NOTE
x
When any of the following
conditions is met, the rearward
detection function may not operate.
x
Directly after the EV system starts.
x
The height of the obstruction is
low such as low walls or trucks
with low loading platforms.
x
The height of the obstruction is
high such as trucks with high
loading platforms.
x
The obstruction is not as large as a
vehicle or wall.
x
The obstruction is thin such as a
signpost.
x
The surface of the obstruction is
not pointed vertically relative to
your vehicle.
x
The obstruction is soft such as a
hanging curtain or snow stuck to a
vehicle.
x
The obstruction is shaped
irregularly.
x
The obstruction is extremely close.
x
When any of the following
conditions is met, the rearward
detection function may not operate
normally.
x
Snow, ice, or mud adheres to the
area around a rear ultrasonic
sensor.
When Driving
i-ACTIVSENSE
4-152