x
The vehicle posture is unstable due
to sudden operation of the steering
wheel, accelerator pedal, or brake
pedal.
x
There is another obstruction near
one obstruction.
x
During inclement weather such as
rain, fog, and snow.
x
High or low humidity.
x
High or low temperatures.
x
Strong winds.
x
The path of travel is not flat.
x
Heavy luggage is loaded in the
luggage compartment or on the
rear seat and the vehicle is tilted.
x
Objects such as a wireless aerial,
fog light, or illuminated number
plate is installed near a rear
ultrasonic sensor.
x
The orientation of a rear ultrasonic
sensor has deviated for reasons
such as a collision.
x
The vehicle is aected by other
sound waves such as the horn,
engine noise, or rear ultrasonic
sensor of another vehicle.
x
When any of the following
conditions is met, the rearward
detection function may operate.
x
Reversing towards a steep
ascending slope.
x
There are grating, wheel blocks, a
road curb, or a bump.
x
There is a hanging curtain or
railroad crossing gate.
x
Reversing near objects such as
foliage, barriers, vehicles, walls, or
fences.
x
The vehicle is driven on rough
roads such as in areas where there
is grass and foliage or o-road.
x
When reversing through low gates,
narrow gates, car washing
machines, tunnels, or into a
mechanical parking garage.
x
A towing bar is installed or a trailer
is connected.
x
If the system performs brake control
and the vehicle is stopped, the
system will continue to hold the
brakes for a brief time unless there is
an operation performed by the
driver.
Collision warning
If there is the possibility of your vehicle
colliding with a vehicle approaching
from the rear on the left or right, or
from the rear while you are driving in
reverse, a warning sound is activated
continuously and a warning is
displayed on the multi-information
display and the active driving display.
Multi-information display
1. “BRAKE!” message is displayed
Active driving display
1. “BRAKE!” message is displayed
NOTE
During brake control, the collision
warning sound is activated
intermittently.
Rear crossing
The Rear Crossing detection function is
designed to reduce the damage in the
event of a collision with a vehicle
approaching from the rear sides while
driving in reverse.
When Driving
i-ACTIVSENSE
4-153
To Next Page
Loading...
