When getting in the vehicle
Manual seat
1. Operate the angle adjustment
(reclining) lever, forward/back
adjustment (sliding) lever on the
side of the front seat, or the walk in
strap.
Pull the walk in strap to fold the
seatback forward and slide the seat
forward.
1. Walk in strap
2. Slide the seat rearward with the
seatback folded forward and then
raise the seatback to return the
operated front seat to its sitting
position after getting in the vehicle.
3. Make sure that the seatback and
slide are firmly locked by
attempting to lightly move the front
seat forward and back.
Power seat
1. Operate the angle adjustment
(reclining) switch, forward/back
adjustment (sliding) switch on the
side of the front seat, or the walk in
switch.
The seatback folds forward while
the upper side of the angle switch is
pressed, and the seat slides forward
while the upper side of the slide
switch is pressed.
1. Walk in switch
2. Angle switch
3. Slide switch
2. Perform the following procedure to
return the operated front seat to its
sitting position after getting in the
vehicle.
1. Press the lower side of the angle
switch. The seatback reclines
while the switch is being
pressed.
2. Press the lower side of the slide
switch. The seat slides rearward
while the switch is being
pressed.
NOTE
After a few seconds have passed since
the power switch was switched OFF,
the seat cannot be moved even if the
walk in switch is operated. The seat
can be moved by operating the walk in
switch again after a door is opened or
closed or the power seat switch is
operated.
Essential Safety Equipment
Seats
2-14
To Next Page
Loading...
