When getting out of the vehicle
Manual seat
1. The seatback can be folded forward
and the seat can be slid forward by
pulling the walk in strap on the
front seat.
1. Walk in strap
2. Slide the seat rearward with the
seatback folded forward and then
raise the seatback to return the
operated front seat to its sitting
position after getting out the
vehicle.
3. Make sure that the seatback and
slide are firmly locked by
attempting to lightly move the front
seat forward and back.
Power seat
1. Press the upper side of the angle
switch. The seatback folds forward
while the switch is being pressed.
2. Press the upper side of the slide
switch. The seat slides forward
while the switch is being pressed.
1. Walk in switch
2. Angle switch
3. Slide switch
NOTE
x
While an occupant is not seated
on the driver’s seat, the seat can
be moved using the walk in
switch.
x
After a few seconds have passed
since the power switch was
switched OFF, the seat cannot be
moved even if the walk in switch
is operated. The seat can be
moved by operating the walk in
switch again after a door is
opened or closed or the power
seat switch is operated.
Essential Safety Equipment
Seats
2-15
To Next Page
Loading...
