Objects such as guardrails and
concrete walls running alongside
the vehicle.
Places where the width between
guardrails or walls on each side of
the vehicle narrows.
The walls at the entrance and exits
of tunnels, turnouts.
A BSM warning indicator light may
flash or the warning beep may be
activated several times when making
a turn at a city intersection.
Turn o the BSM while pulling a
trailer or while an accessory such as a
bicycle carrier is installed to the rear
of the vehicle. Otherwise, the radar’s
radio waves will be blocked causing
the system to not operate normally.
In the following cases, it may be
dicult to view the illumination/
flashing of the BSM warning
indicator lights equipped on the
door mirrors.
Snow or ice is adhering to the door
mirrors.
The front door glass is fogged or
covered in snow, frost or dirt.
The rear side radar sensor of the BSM
may be regulated under the radio
wave related laws of the country
where the vehicle is driven. If this
system is used abroad, it may be
necessary to turn
o
the system.
Refer to Rear Side Radar Sensor on
page 4-79.
The system switches to the Rear
Cross Trac Alert (RCTA) function
when the selector lever is shifted to
the reverse (R) position.
Refer to Rear Cross Trac Alert
(RCTA) on page 4-107.
▼
Blind Spot Monitoring (BSM)
Warning Indicator Lights/Display
Indicator/Blind Spot Monitoring
(BSM) Warning Beep
The BSM system notifies the driver of
the presence of vehicles in adjacent
lanes or at the rear of the vehicle using
the BSM warning indicator light, the
warning sound and the display
indicator while the systems are
operational.
When Driving
i-ACTIVSENSE
4-90
MX30_8JD4-EA21G_Edition4_new 2021-8-5 15:25:29
To Next Page
Loading...
