Mazda MX-30 2022 - Page 294

Consult an Authorized Mazda Dealer
for repair, painting, or replacement
of the front/rear camera, front
bumper, liftgate and door mirrors.
Heed the following cautions to
assure that the 360°View Monitor
operates normally.
Do not modify the vehicle
suspensions or lower/raise the
vehicle body, or both.
Always use tires of the
specified
type and size for the front and rear
wheels. Consult an Authorized
Mazda Dealer for tire replacement.
When the display is cold, images
may leave trails or the screen might
be darker than usual, making it
dicult
to check the vehicle
surroundings. Always
confirm
the
safety at the front and around the
vehicle visually when driving.
The method for parking/stopping
the vehicle using the 360°View
Monitor
diers
depending on the
road circumstances/conditions and
the vehicle conditions. When and
how much you turn the steering
wheel will
dier
depending on the
situation, therefore always check the
vehicle surroundings directly with
your eyes while using the system.
Also, before using the system, always
make sure that the vehicle can be
parked/stopped in the parking/
stopping space.
NOTE

If there are water droplets, snow, or
mud on the camera lens, wipe it o
using a soft cloth. If the camera lens
is especially dirty, wash it o with
mild detergent.

If the camera lens is touched or there
is any dirt on it, it could aect the
screen image. Wipe the lens using a
soft cloth.

If the area where the camera is
installed, such as the front bumper,
liftgate or door mirrors, has been
damaged in a vehicle accident, the
camera (position, installation angle)
may have shifted. Always consult an
Authorized Mazda Dealer to have
the vehicle inspected.

If the camera is subjected to
excessive changes in temperature
such as by pouring hot water on the
camera during cold weather, the
360°View Monitor may not operate
normally.

If the vehicle is driven during cold
temperatures and the camera
temperature decreases, the top view
and the side view may become
unclear. However, this does not
indicate a problem. If the vehicle is
stopped for a while and the camera
temperature increases, the top view
and the side view will return to the
normal condition.

If the lead-acid battery voltage is
low, the screen might be temporarily
dicult to view, however, this does
not indicate a problem.

The 360°View Monitor has
limitations. Objects under the
bumper or near both ends of the
bumper cannot be displayed.

Obstructions above the upper image
range of the camera are not
displayed.

Under the following conditions, the
screen might be dicult to view,
however this does not indicate a
problem.

The temperature near the lens is
high/low.
When Driving
i-ACTIVSENSE
4-146
MX30_8JD4-EA21G_Edition4_new 2021-8-5 15:25:29