Black plate (208,1)
l
A new CD may have rough edges on
its inner and outer perimeters. If a disc
with rough edges is used, proper
setting will not be possible and the CD
player/In-dash CD changer will not
play the CD. Remove the rough edges
in advance by using a ball-point pen or
pencil as shown below. To remove the
rough edges, rub the side of the pen or
pencil against the inner and outer
perimeter of the CD.
l
When driving over uneven surfa ces,
the sound may jump.
l
The CD player/In-dash CD changer has
been desig ned to play CDs bearing the
identification logo as shown. No other
discs can be played.
CD Player
In-dash CD changer
l
Be sure never to touch the signal
surface when handling the CDs. Pick
up a CD by grasping the outer edge or
the edge of the hole and the outer edge.
l
Do not stick paper or tape on the CD.
Avoid scrat ching the reverse side (the
side without a label).
l
Dust, finger smudges, and dirt can
decrease the amount of light reflected
from the signal surface, thus affecting
sound quality. If the CD should
become soiled, gently wipe it with a
soft cloth from the center of the CD to
the edge.
l
Do not use record sprays, antistatic
agents, or household spray cleaners.
Volatile chemicals such as benzine and
thinner can also damage the surface of
the CD and must not b e used. Anything
that can damage, warp, or fog plast ic
should never be used to clean CDs.
6-14
Interior Comfort
Audio System
MX-5_8U35-EA-05F_Edition2 Page208
Tuesday, June 14 2005 2:32 PM
Form No.8U35-EA-05F
To Next Page
Loading...
