Black plate (247,1)
NOTE
The tire sealant can be used at outside
temperatures down to
_
30°C.
In extre mely cold temperatures (0°C
(32°F) or below), the tire sealant
hardens easily and injection of the
sealant will be difficult. Warm the
sealant inside the vehicle before doing
the injection work.
6. Remove the cap from the bottle. Screw
on the injection hose with the bottle's
inner cap left on to break the inner cap.
Injection hose
Bottle
7. Remove the valve cap from the flat
tire. Press the back of a valve core tool
to the core of the tire valve and bleed
all the remaining air.
Valve core tool
Valve
Valve cap
CAUTION
If there is air remainin g in the tire when
the valve core is removed, the valve
core could fly out. Remov e the valve
core carefully.
8. Turn the valve core counte rclockwise
with the valve core tool and remove the
valve core.
Valve
Valve core
NOTE
Store the valve core in a place where it
won't get dirty.
9. Remove the plug from the injection
hose and insert the injectio n hose into
the valve.
Plug
Injection hose
In Case of an Emergency
Flat Tire
7-9
MX-5_8U35-EA-05F_Edition2 Page247
Tuesday, June 14 2005 2:33 PM
Form No.8U35-EA-05F
To Next Page
Loading...
