ENGLISH ENGLISH
5 5
• Before plugging in the applian-
ce, make sure the voltage and
frequency values of the supply
mains correspond to the ratings
indicated on the label featuring
the appliance’s technical data.
• The wall socket must be fitted
with an efficient earth contact.
Consequently, it is essential to
make sure the earth system is
efficient and in conformity with
current safety rules. If in any
doubt, have the system thorou-
ghly checked by personnel with
the appropriate professional
skills.
It is compulsory to earth the ap-
pliance. The manufacturer can-
not be held responsible in the
event this regulation is not com-
plied with.
• It is essential to make sure the
ratings of the system are suita-
ble for the power absorbed by
the appliance - as indicated on
the label featuring the technical
data - and that the wall socket is
protected against overcurrents.
• Do not use extension cables,
plug adapters for multiple socke-
ts or makeshift connections.
• The motor must rotate clockwi-
se. If the rotation of three-phase
motors is to be inverted, by in-
verting the two power supply wi-
res inside the plug, this must be
carried out by skilled personnel.
• The appliance is suitable for in-
door use only. Do not install the
appliance outdoors.
• For an optimal functioning of the
appliance a room temperature
range from 15°C to 35°C is sug-
gested.
• Thoroughly clean the appliance
at the first installation; follow the
instructions in chapter 8.
• The appliance is not suitable for
installation in an area where a
water jet could be used.
• For the correct use of the grin-
ding blades, at the first installa-
tion or whenever the grinding
blades have been replaced,
grind some doses of coffee. Do
not use those first doses.
• The appliance is only to be in-
stalled in locations where its use
and maintenance is restricted to
trained personnel.
• A minimum clearance of 15 cm
(6.0 inches) is required between
the grinder and any adjacent
walls (or other adjacent applian-
ces). Frontal side must be open.
• Do not install the appliance near
to water dispenser or similar
product that could throw water
jet on the appliance.
• The filter holder fork must be
suitably set according to the in-
structions in chapter 8.
To Next Page
Loading...
