PREPARING THE GRINDER
REMINDER: Make sure your grinder is turned off and unplugged.
A. Take the Guide Rod included with this product.
B. Screw in the threaded end of the Guide Rod into the handle attachment hole of your grinder. This is
the threaded hole located on the right side of your grinder.
C. Screw it in as far as it can go.
D. Tighten the lock nut of the Guide Rod until it is snug to secure it on to the grinder.
WARNING: Do not overtighten the lock nut and do not use pliers to turn the Guide Rod to
avoid any damage.
ANGLE BRACKET
VISE
LOCK NUT
GUIDE ROD
To Next Page
Loading...