B. Attaching Small Blades to the Sharpener Clamp
The vise can be turned around to be able to fit blades of smaller width.
1. Unscrew the vise handle until it is fully detached from the clamp.
2. Remove the outer half of the vise by sliding it out of the assembly.
3. Turn it so that the opposite side will be facing the assembly.
4. Re-attach it to the assembly.
5. Screw back the Vise Handle.
WARNING: Do not overtighten the vise to avoid damaging the blade.
Unscrew and remove
Vise Handle
Remove Vise
To Next Page
Loading...