Discman 2 / 230 V 29
4 Working with the Discman
4.1 Connecting to the power supply
For an optimum workplace layout, route the power cable
down from the ceiling.
4.2 Before commissioning
Before you start working, remove the locking bolt and the Allen key from the device!
4.3 Grinding angle setting
To set the grinding angle, release screw [1].
Turn the angle adjuster [2] manually to the desired position.
Turning by one number is equivalent to changing the angle by one
degree. The angle adjuster latches every 0.5 degrees.
Hand-tighten the screw [1] with an Allen key.
To Next Page
Loading...