Do you have a question about the MC Crypt USB-100 and is the answer not in the manual?
Rotary controls to adapt mixer inputs to the output level of the source of signal concerned.
Control to adjust the volume of the headphones.
Control to adjust the volume of the headphones, with a warning about setting to zero before handling.
Defines which signal is played back via headphones (CH1, CH2, or both).
Equaliser controls to change the sound by adjusting treble and bass range.
Switches used to select individual inputs (signal sources) for the channels.
Faders for adjusting the level of each channel, with minimum and maximum positions described.
Slide control for cross-fading and mixing between channels CH1 and CH2.
Socket for connecting a dynamic or condenser microphone with a 6.3 mm jack.
6.3 mm jack socket for connecting headphones.
Control to set the output level at the MASTER OUTPUT.
Two stereo cinch inputs for connecting audio devices with line level output.
Inputs exclusively for connecting record players with magnet systems.
Input for connecting a microphone.
Asymmetrical stereo cinch outputs for the mixer's output signals.
6.3 mm jack bushing for connecting headphones.
Describes the correct sequence for switching the mixer and connected devices on and off to prevent damage.
Instructions on how to select desired inputs using input selection switches, advising to minimise volume first.
Step-by-step guide to setting initial volume levels for channels, master output, and amplifier.
Guidance on using the CUE control for pre-listening through headphones and related safety precautions.
Explanation of how to use the cross-fader to mix signals between channels.
Instructions on setting the microphone input level and how the microphone signal is mixed.
Steps for selecting USB interfaces and starting playback from a computer.
Details on using USB interfaces for recording onto a computer's hard disk via audio recording software.
Troubleshooting steps for when the device fails to power on, checking power connections and mains supply.
Troubleshooting for no audio output, checking input signals, levels, and connections.
Diagnosing humming sounds, checking record-player earth connections and potential buzz loops.
Steps to resolve issues where a specific channel is not functioning, checking cables and amplifier balance.
Troubleshooting distorted audio, checking mixer levels, amplifier modulation, and device specifications.
| Brand | MC Crypt |
|---|---|
| Model | USB-100 |
| Category | DJ Equipment |
| Language | English |
Loading...