Need help?Do you have a question about the MC2 Audio MC1250 and is the answer not in the manual?
General| Channels | 2 |
|---|---|
| Input Sensitivity | 0.775V/1.0V/1.4V |
| Dimensions | 88mm x 482mm x 428mm |
| Weight | 22kg |
| Input Impedance | 10k ohms balanced |
| Voltage Gain | 32dB |
| Damping Factor | >400 |
| Cooling | Variable speed fan |
| Frequency Response | 20Hz - 20kHz |
Key technical parameters of MC series amplifiers, including power and distortion.
Further technical details like input impedance, noise, damping factor, and protection features.
Critical safety precautions related to electrical connections and handling.
Key warnings regarding electric shock, water, heat, and proper usage.
Specific wiring instructions for balanced and unbalanced audio inputs.
How to configure the amplifier for bridged mono output.
Connection details for bridged mono setup.
Explanation of the 2 ohm/4 ohm switch function and load impedance.
Description of rotary encoders for adjusting signal levels.
Function of mute switches and status indication.
How the link switch affects channel level and limiter control.
Explanation of peak reading meters and their reference points.
Details on the digital signal limiters and their configuration.
Indicators for rear panel switches and load conditions.
How release time affects limiter behavior and automatic gain control.
Control of LED column behavior when adjusting level controls.
How switches 4 and 5 set the limiter threshold level.
How switches 6 and 7 configure limiter mode and release time.
How switch 8 sets the limiter attack time.
How the remote system replicates front panel controls and features.
Key features like daisy-chaining, grouping, and security.
Details on the cable and connector requirements for remote control.
How to connect the amplifier to the controlling computer using RS485.
Steps to configure the PC software and identify amplifiers.
To Next Page
