McCall Refrigeration / 81 West Holly Street / Parsons, TN 38363
Phone (731) 847-5570 / Fax (731) 847-9012 / 1-888-REACH-IN (1-888-732-2446) / www.mccallrefrigeration.com
January 2007 / Printed in U.S.A.
Model 7-7020T, 7-7045T, 7-7070T
Cabinet exterior: heavy gauge anodized aluminum. Stainless steel
door and hatch cover.
Cabinet interior: mill finish aluminum.
Standard Features
• Top mounted compressor and evaporator coil.
• Thermostatic temperature control.
• Hot gas condensate evaporator.
• Automatic defrost.
• Cord and plug attached.
• Master power switch.
• Windrunner gradient air displacement process
• R-134a refrigerant.
• Automatic interior light.
• Dial Thermometer.
• Adjustable doorstops
SPECIFICATONS
Cabinet - Cabinets are all metal, inside and out. The
top, back, and bottom are made of galvanized steel.
In addition, all seams are closed and sealed, with
metal edges turned away from the exposed
surface. The result is an integrated structural frame.
Internal corners are coved to conform to NSF
standards. Automatic interior lighting is controlled
by a light switch concealed in the door hinge. The
cabinet is supported on four 6 inch adjustable legs.
Doors - Constructed of metal, refrigerator doors are
self-closing and fully insulated. Their cam-lift
hinges are epoxy-coated and self-lubricating.
Hinges also have a safety stop that holds the door
open, preventing overswing. Chrome-plated pull
handles have built-in cylinder locks. The full-
perimeter, magnetic vinyl gaskets are removable
without the use of tools. Doors easily lift off, and
door perimeters have a built-in, low wattage, and
anti-condensate heater. Door openings are
protected by an impact-resistant, nonconductive
PVC breaker strip with no exposed screws
or fasteners.
Insulation - Cabinet body, doors, and evaporator
coil housings are filled with pressure-injected
polyurethane foam.
Interior Shelves - Three wire shelves are standard
per section. Shelves have a runner spaced 3/4 inch
O.C. with two reinforcing bars 8 1/2 inch O.C.
coated with 7 mils of baked-on gray epoxy. The
shelves have a saline spray corrosion resistance of
600 hours. Shelves will support 250 pounds each.
They are supported on stainless steel pilasters
(1000 series) & aluminum pilasters (2000-4000
series), and are adjustable on 1 inch centers. All
shelves are interchangeable and can be adjusted
without tools or special parts.
Self-Contained Refrigeration - The complete
refrigeration assembly is mounted on top of the
cabinet behind a removable hatch cover.
Refrigeration components include a hermetically
sealed compressor, cap tube, thermostatic
temperature control, high-humidity evaporator coil
and hot gas condensate evaporator. The system is
balanced to maintain 38°F average internal air
temperature. Windrunner gradient air displacement
process provides even air flow and temperature
control throughout the cabinet. All components are
factory installed and tested, and supplied with an
attached cord and plug, master switch, and exterior
dial thermometer (1000 series) dial thermometer
(2000-4000 series).
7000 S
ERIES
R
EACH
-I
N
R
EFRIGERATORS
Approval :
McCall Refrigeration specification sheets are available
online @ www.mccallrefrigeration.com
AIA #
ITEM #
MODEL #
PROJECT NAME
SIS #
7-7020T
7-7045T
7-7070T
CLASSIFIED TO
NSF (STD-7-1999)
To Next Page
Need help?
General
