What to do if McConnel Robocut RC75 Robotics track ‘jams’ when steering?
If the McConnel Robotics track jams during steering, it's likely due to material such as stones, rocks, or earth trapped between the rollers, sprockets, idler roller, and the track. To resolve this, remove the trapped material by turning the track in both directions while slightly slackening it. If possible, raise the machine at the same time.
Why does McConnel Robocut RC75 Robotics track slacken frequently?
Frequent slackening of the McConnel Robotics track can be attributed to a faulty tensioner valve, a damaged tensioner seal, or worn tensioner components. Suggested solutions include replacing the valve, replacing the seal, or replacing the worn components.
What to do if McConnel Robocut RC75 is overheating?
Overheating in McConnel Robotics can occur due to a lack of oil, arduous operating conditions or a hot climate, or brakes binding. You can add oil, and check the brake release pressure. For further assistance, it is advisable to contact your dealer.
How to fix McConnel Robotics track damage?
Track damage in McConnel Robotics, such as excessive tread wear or loosening/breaking of the internal structural steel rope, indicates the need to replace the track.
What to do if McConnel Robotics motor runs but gear unit not working?
If the motor runs but the gear unit isn't working in your McConnel Robotics, the issue could stem from a wrongly assembled motor, an internal malfunction, or a jammed brake. Check the coupling between the motor and gear unit and check the braking system. For internal malfunctions, it is advisable to contact your dealer.
What to do if McConnel Robotics brake not releasing?
If the brake is not releasing on your McConnel Robotics, it could be due to a lack of brake pressure or faulty brake seals. Check the brake connections. For faulty brake seals, it is advisable to contact your dealer.
What causes McConnel Robotics excessive vibration?
Excessive vibration in McConnel Robotics can be caused by internal malfunctions or worn seals. It is advisable to contact your dealer.
What to do if McConnel Robocut RC75 Robotics brakes not locking?
If the brakes are not locking on your McConnel Robotics, this could be due to residual pressure in the circuit or worn brake components. Check the hydraulic system. For worn brake components, it is advisable to contact your dealer.
Why upper track does not stay in position on McConnel Robocut RC75?
If the upper track of the McConnel Robotics does not stay in position, it is likely due to a worn track slide or upper roller. You should replace the slide or replace the upper roller.
Why lower track does not stay in position on McConnel Robotics?
If the lower track of the McConnel Robotics does not stay in position, it may be caused by a worn lower track guide or a worn lower roller. To fix this, replace the lower track guide or replace the lower roller.
Terms and procedures for machine warranty coverage, limitations, and claims.
Crucial safety guidelines, hazard definitions, and operational precautions.
Location and function of E-stop buttons and safety devices.
Labels and identifies all controls on the remote unit.
Explains operation of the left and right joysticks for various functions.
Guide to common issues, solutions, and identification of fuses and relays.
To Next Page
General