McCulloch MC1350 - User Manual

Questions and Answers

P
Patricia SotoAug 1, 2025
Why is my McCulloch MC1350 not heating up?
- O
  owensjeremyAug 1, 2025
  If your McCulloch Steam Cleaner isn't heating up, start by ensuring the power cord is securely plugged into an electrical outlet. Check your household circuit breaker or ground fault interrupter and reset it, or replace the fuse if necessary. If the water reservoir is empty, refill it. Mineral build-up can also prevent heating; refer to the manual section on cleaning procedures to address this. If the issue persists, immediately stop using the unit, unplug it, and contact customer service for assistance.
W
walkeramandaAug 7, 2025
Why is the steam output weak on my McCulloch MC1350?
- B
  Bradley WilliamsAug 7, 2025
  If the steam output from your McCulloch Steam Cleaner is weak or intermittent, the water level in the water reservoir may be running low; refill it. Mineral build-up in the unit could also be the cause; refer to the manual section on cleaning procedures to address this.
M
marcia27Aug 13, 2025
What to do if McCulloch Steam Cleaner has excessive water in steam?
- K
  Kristina AlexanderAug 13, 2025
  If you notice an excessive amount of water in the steam from your McCulloch Steam Cleaner, it's likely due to water condensation in the steam hose. To resolve this, point the nozzle towards a sink, tub, or the ground and shake it while pressing the steam trigger until the excess water is released.
T
Thomas HoffmanAug 18, 2025
How to fix McCulloch MC1350 Steam Cleaner accessories not staying connected?
- B
  Brian MillerAug 18, 2025
  If the accessories on your McCulloch Steam Cleaner do not stay firmly connected to the steam nozzle, it's likely that the accessories were not properly installed. Check to ensure that all accessories are correctly connected, following the procedures outlined in the manual.
D
Dawn BoltonAug 25, 2025
What to do if no steam but can hear pump on McCulloch MC1350?
- B
  Billy Ramirez MDAug 26, 2025
  If you hear the pump running but no steam is coming out of your McCulloch Steam Cleaner, the water treatment cartridge may be dry. Allow the pump to prime water through it. Alternatively, allow the water treatment cartridge to soak in water for one minute before installing it into the unit.