the groun d contours rather than ac ross th em.This will often stabilise
the effect.
*I n heavily miner alised area s th e operator ma y need to sweep the coil
10 -20mm above the groun d.This should give a more stable Threshold
and less ground noise.
*Ver y sudden or large cha nges in the miner alisa tion of an ar ea may
pr oduc e a signal from the dete ctor.U sually th is signal is very broad and
of ten only present in one direction.
Note:The MCD Series are‘motion’detectors.This means the coil must
be moving th e target,or the targ et moving over th e coil,in order from
the detector to ‘see ’it.
Aft er-sale Serv ice:
Thank you for choosing our devices. We are rea dy to off er high-class
after-sales service .
The service s include:
1. Choose the close appointed repair unit if you want to have a
mainten ance service.
2. If there is any question or difficulty in maintenance, please contact
the local repair center.
The gu arantee service is not applicable to th e security check devices in
on e of th e followin g conditions. However, they can be repaired with
some charge.
1. The trademark or the series number of the devic e or parts is torn or
cha nged .
2. The device is damaged by improper use, ma inten ance, or storage.
3. The device is damaged by unavoidable force.
4. The device has be en maintained by non-appointed repair unit or
pe rsonally.
5. The device has been combined or asse mbled with devices from oth er
To Next Page
Loading...
