Emergency Depressu rization
lf it is necessary
to
quickly
depressurize the Compressor, turn the Power
Switch OFF.
Then,
pull
on the ring on the Safety Valve to
quickly
release stored air
pressure.
Automatic
Shut off System
This
unit is equipped
with Thermal
Overload
Protection.
1.
lf
the Compressor automatically shuts
off
before reaching
its
normal cutoff
pressure:
a. Turn it off and unplug
it for 15 minutes.
b.
Plug it
back
in.
c. Turn unit on and
resume operation.
Possible causes
of
repeated
automatic
shut off of the
compressor are:
a. Using
an extension cord that
is too long
or
narrow;
b. An
air
leak
or open
hose
causing
the compressor
to cycle too
often
and
build
up heat.
c.
Turning
Air Compressor off and
on again too
quickly.
Correct any
issues
before
further
use to
avoid damage to the compressor.
2.
3.
Procedures not specifically explained
in this manual must
be
performed
only by a
qualified
technician.
TO PREVENT SERIOUS
INJURY FROM ACCIDENTAL OPERATION:
Turn
the
Power
Switch
'.OFF"
and unplug the Compressor
from its electrical outlet
before
performing
any
inspection, maintenance, or cleaning
procedures.
TO PREVENT SERIOUS
INJURY FROM COMPRESSOR
FAILURE:
Do not use damaged equipment.
lf abnormal noise or
vibration occurs,
have the
problem
corrected before
further use.
Gleaning,
Maintenance, and
Lubrication
1. BEFORE
EACH USE, inspect the
general
condition of the air compressor.
Check
for:
.
loose hardware,
.
misalignment or binding
of moving
parts,
.
cracked
or broken
parts,
.
damaged
electricalwiring, and
.
any other condition
that may
affect its safe operation.
AFTER USE, wipe external surfaces of
the
compressor
with a clean cloth.
Awanuruc!
To PREVENT sERrous
INJURY:
lf
the supply
cord of this
compressor is damaged,
it must be replaced
only by a
qualified
service
technician.
2.
la-_- r1f16 EaEDI F^- 4-
-L-:--l
-..--4:---
-t^-^^
^-tt,
ooo oaa EtaT rt^^^ o
To Next Page
Loading...
